要講得太多還是直接回一篇 我沒買APU.不過看到吃土雞就知道了 A10-7860k:3.6G---4.0G Socket FM2+,support for PCIe 3.0 four CPU cores based on the Steamroller microarchitecture eight Compute Units based on GCN 2nd gen microarchitecture CPU:吃土雞架構 GPU:Sea Islands 最白話的講法:拉FSB/Bclk會動到HTT,NB,RAM,Igpu 以上皆可用除頻方式增減頻率.Igpu是怎樣除頻法我就不知道了 超頻就是先不動除頻.電壓硬幹先.這樣才會獲得最高效能 ram直接設1.65V以上好嗎.然後其他直接+0.1V拜託 想超頻就是要接受耗電爆炸.尤其是吃土雞核心的.超核爆 如果加壓都不行再來調除頻跟ram timing 你的是K版.所以可以直接拉倍頻.那htt,nb,ram ,igpu都不會連動 超不上去就是電壓硬幹了沒別招 再來如果你有注意看我po給你的網頁 RAM-Overclocking: Like I have already mentioned the iGPU benefits significantly from higher memory frequencies. 1866 MHz are usually no problem with stock voltages – given that the memory kit is working at this speed. I’m using a 2 x 2 GiB G.Skill Pi Kit with 2400 MHz on 1,65 Volt. The timings are 9-11-9-28.However if I increase the memory speed to 2133 MHz or higher, the sytem would not boot anymore and the post LED would show 51 which is a memory issue according to the mainboard manual.so what do we do ? My CPU requires to raise the NB-Voltage for 2133 MHz or higher. I had to use 1,2875 Volt to get the system running. Of course this depends on the CPU and you have to test step by step. 剛好作者也是拿Gigabyte的板子.你可以試試看.還有可以按Ctrl+F1看有啥隱藏選項 ※ 編輯: pold123 (59.104.163.195), 04/09/2017 23:56:31 ※ 編輯: pold123 (59.104.163.195), 04/10/2017 00:05:50