作者coolboychiu ()
看板Physics
标题[问题] 全功率带宽
时间Sun Oct 9 23:20:25 2011
刚刚在看电子学,有一句话看不懂,跟同学後还是不懂,
想说来物理版问问看,以下就是我们看不懂的地方:
full-power bandwidth:
It's the frequency at which an output sinusoid with amplitude equal to
the rated output voltage of the op amp begins to show distortion due to
slew-rate limiting.
我已经卡快一个多小时了,请各位帮帮忙,感恩~
-----------------------------------------------------------------------
我把全文打上来好了,有点长,麻烦各位帮个忙,感恩
昨天熬夜都在想这个,想不出来好难过
Op-amp slew-rate limiting can cause nonlinear distortion in sinusoidal
waveforms. Consider the unity-gain follower with a sine-wave input given by
v_i = V_i*sin(wt)
The rate of change of this waveform is given by
dv_i
---- = wV_i*cos(wt)
dt
with a maximum value of wV_i. This maximum occurs at the zero crossings of
the input sinudoid. Now if wV_i exceeds the slew rate of the op amp, the
output will be distorted. Observe that the output cannot keep up with the
large rate of change of the sinusoid at its zero crossings, and the op amp
slews.
The op-amp data sheets usually specify a frequency f_M called the full-power
bandwidth. (接下来就是说明什麽是fpbd,就是上面那段) If we denote the rated
output voltage V_o,max, then f_M is related to SR as follows:
w_M*V_o,max = Slew rate (SR)
Thus,
f_M = SR/(2*pi*V_o,max)
It should be obvious that output sinusoids of amplitudes smaller than V_o,max
will show slew-rate distortion at frequencies higher than w_M. In fact, at a
frequency w higher than w_M, the maximum amplitude of the undistorted output
sinusoid is given by
V_o = V_o,max*(w_M/w)
--
※ 发信站: 批踢踢实业坊(ptt.cc)
◆ From: 140.112.248.193
1F:推 herbert570:在该频率的时候,输出弦波会因为slew-rate的关系没办法 10/10 00:42
2F:→ herbert570:跟上输入弦波,而产生distortion 10/10 00:42
3F:→ herbert570: ↑会"开始"因为 10/10 00:42
4F:推 Leadgen:频宽不够,所以速度跟不上? 10/10 12:29
※ 编辑: coolboychiu 来自: 140.112.248.193 (10/10 13:58)
5F:→ threedices:op amp慢半拍 跟不上输入的讯号.. 10/10 13:43