各位好 最近在网路上看到一段很有趣的文章 很想实际操作看看 但碍於英文不好 所以请各位高手帮忙翻译一下 谢谢 1. Place the LilyPad right side up on the backside of the glove such that pins 5-13 are near the fingers. The 「LilyPad Arduino」 text should be upside down when you hold the glove with the fingers up. 2. Take a long strand of conductive thread and tie it around the LilyPad's port 13. Knot it once or twice tightly around the port so that it is firmly connected. 3. Put both ends of the knot through the needle, and sew with the thread up on the index finger. When you reach near the top of the index finger, sew the thread around on the left side to the front of the finger. 4. Make a few stitches on the finger tip to give a larger surface for the switch. 5. When you』re done, tie the thread in a knot and cut off loose ends. 6. Repeat steps 2-5 with the other switches. This is where they go: 这段话出於这个网站 http://www.instructables.com/id/Musical-Glove/ 拜托各位高手了 谢谢 --

※ 发信站: 批踢踢实业坊(ptt.cc) ◆ From: 74.108.14.119