課程名稱︰熱力學 課程性質︰必修 課程教師︰黃信富 教授 開課學院：工學院 開課系所︰機械工程學系 考試日期（年月日）︰2015/11/12 考試時限（分鐘）：120 是否需發放獎勵金:是 試題 : 1.(50pts) The turbocharger of an internal conbustion engine consists of a turbine and a compresser. Hot exhausts gases flow through the turbine to produce work and the work output from the turbine is used as the work input to the compressor. The pressure of ambient air is increased as it flows through the the compressor. The purpose of a turbocharger is to increase the pressure of air so that more air gets into the cylinder, and more fuel can be burned, creating more power. Exhaust air enter the turbine at 400°C and 120kPa at the rate of 0.02kg/s and leave at 350°C. Air enters the compressor at 50°C and 100kPa and leaves at 130kPa at a rate of 0.018kg/s. The compressor increases the air pressure with a side effect: It also increases the air temperature, causing the possibility of an engine knock. To avoid this, an aftercooler is placed after the compressor to cool the warm air by cold ambient air before it enters the engine cylinders. It is estimated that the aftercooler must decrease the air temperature below 80°C if knock is to be avoided. The cold ambient air enters the aftercooler at 30°C and leaves at 40°C. Disregard any frictional losses in the turbine and the compressor and treating the exhaust air as air, determine (a)(30pts) the temperature of the air at the compressor outlet (b)(20pts) the minimum volume flow rate of ambient air to avoid knock. 圖示： http://i.imgur.com/OL9WcD0.jpg 2.(25pts) Two tanks (A and B) are seperated by a partrition. Initially tank A contains 2-kg steam at 1Mpa and 300°C while B contains 3-kg saturated liquid-vapor mixture at 150°C with a quality of 50%. The partition is removed and the two sides are allowed to mix until the mechanical and thermal equilibrium are established. If the pressure at final state is 300kPa, determine: (a)(16pts) the temperature and quality of steam(if mixture) at the final state (b)( 9pts) the amount of heat lost from the tanks. 圖示： http://i.imgur.com/r5U8Lli.jpg 3.(25pts) An insulated 8-m^3 rigid tank contains air at 600kPa and 400K. A valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 200kPa. The air temperature during this process is maintained constant by an eletric resistence heater placed in the tank. Determine the eletrical energy supplied to air during this process. Gas constant R = 0.287 kPa * m^3 / kg * K 圖示： http://i.imgur.com/o0XHhMg.jpg --

※ 發信站: 批踢踢實業坊(ptt.cc), 來自: 140.112.243.139 ※ 文章網址: https://webptt.com/m.aspx?n=bbs/NTU-Exam/M.1447332383.A.E6B.html ※ 編輯: HarryCheng (140.112.243.139), 11/12/2015 20:47:17 ※ 編輯: HarryCheng (140.112.243.139), 11/12/2015 20:50:45