作者linefong (下一站天王)
看板Cad_Cae
標題[問題] ANSYS分析上的問題
時間Fri Jul 8 13:41:26 2005
想請教一下~
我在分析ANSYS的時候
出現了以下的錯誤訊息
但是我不太懂他的意思
*** ERROR *** CP= 62.531 TIME= 13:36:27
The value of UY at node 8694 is 3.733233267E+10. It is greater than
the current limit of 1000000. This generally indicates rigid body
motion as a result of an unconstrained model. Verify that your model
is properly constrained.
*** ERROR *** CP= 63.062 TIME= 13:37:03
*** MESSAGE CONTINUATION ---- DIAGNOSTIC INFORMATION ***
If one or more parts of the model are held together only by contact
verify that the contact surfaces are closed. You can use the CNCHECK
command to check the initial contact status in the SOLUTION module.
希望有高手可以幫幫我唷
謝謝~~
--
※ 發信站: 批踢踢實業坊(ptt.cc)
◆ From: 163.25.96.162
1F：→ ac0118:應該是你的接觸面設錯了…兩者可能沒有接觸…218.164.143.129 07/08
2F：→ ac0118:去help看看CNCHECK這個指令吧…應該有解決方法…218.164.143.129 07/08
3F：→ ac0118:ANSYS的HELP做的不錯…在發生問題時很有幫助的…218.164.143.129 07/08
4F：推 skygogo:大大好厲害阿..但是我想請問一下唷.. 163.25.96.161 07/09
5F：→ skygogo:CONTACT 有一定要接觸嗎..還是可以有GAP? 謝謝 163.25.96.161 07/09
6F：推 ac0118:那要看你是做什麼分析…像掉落試驗就有gap 218.164.129.66 07/09
7F：→ ac0118:理論上應該是要你的問題而定… 218.164.129.66 07/09