作者kedy ()
看板VoIP
标题Re: [问题] Cisco 2600 + 2FXS VIC 建置VoIP环境
时间Sat Jan 6 22:03:25 2007
各位板友大家好,
这几天小弟把一般的话机接好, 也做了简单设定,
做完之後遇到一个很奇怪的问题,
我总共用了三种通话端,
[硬体SIP Phone] [软体SIP Phone] [POTS Phone]
我有用OnDo架了一台 SIP Proxy, 然後不用注册,
因为要注册的话Cisco Router上不知道怎麽设定
(IOS 12.2似乎还不支援设定SIP认证的帐号密码)
以下是我简单的VoIP测试环境:
Cisco 2600 with VIC-2FXS (IOS 12.3)
传统话机x2
OnDo SIP Proxy Server
X-lite, SJPhone (WinXP)
硬体IPPhone
现在两支分机互打没有问题~ 都可以讲话,
然後其他的X-lite SJPhone或者IPPhone互打也没问题都可讲话,
一切正常~~
问题出在只要打到传统电话的话, 传统电话听得到声音,
可是讲话的时候受话端都听不到orz
我用ethereal 看, 只有软体端送出的RTP封包
都没有看到传统话机经由cisco router送出来的rtp封包
不晓得这是什麽问题呢??
有没有有经验的板友可指导一下...谢谢^^
然後这边是我的组态:
voice dsp release early
!
voice service voip
sip
!
voice class codec 1
codec preference 2 g711alaw
codec preference 3 g711ulaw
codec preference 5 g729r8
!
no voice hpi capture buffer
no voice hpi capture destination
!
call rsvp-sync resv-timer 15
!
voice-port 1/1/0
cptone TW
description 255
station-id number 1000
caller-id enable
!
voice-port 1/1/1
cptone TW
station-id number 1001
caller-id enable
!
dial-peer voice 500 voip
application session
destination-pattern .T
session protocol sipv2
session target sip-server
session transport udp
dtmf-relay rtp-nte
codec g711alaw
!
dial-peer voice 1000 pots
application session
answer-address 123
destination-pattern 1000
port 1/1/0
!
dial-peer voice 1001 pots
application session
answer-address 3333
destination-pattern 1001
port 1/1/1
!
gateway
timer receive-rtcp 5
!
sip-ua
retry invite 3
retry response 3
retry bye 3
retry cancel 3
timers trying 1000
sip-server ipv4:134.208.0.36
!
--
※ 发信站: 批踢踢实业坊(ptt.cc)
◆ From: 134.208.0.38